Brandmotion 9002-9516 Bedienungsanleitung PDF herunterladen

9516 Instructions 9-27-12 Tel 734-619-1250

1 of 3 Toll Free 877-276-6456

Fax 480-247-5999

9002-9516 Installation Instructions (Auto Dimming/Comp/Temp Video

Display Mirror)

IMPORTANT: Read before installing. For the latest full color instructions please visit www.brandmotion.com.

Mirror Mounting - This mirror has a Wedge/ D-tab style mounting base. Please check our application guide to ensure

sure it is compatible with your vehcile (adapters are available for specific applications separately). Slide the mirror onto

the tab. Torque for the mirror screw that attaches to the windshield tab is 1.8 Nm (16 lb-in) and cannot exceed 2.2 Nm

(19.5 lb-in).

Camera requirements - The camera signal must be strong enough for the mirror to detect signal when reverse is

engaged. We recommend that the camera be connected to mirror prior to installation to confirm compatiblity. Best results

are on cameras that have a .8- 1.6 VDC coming out of video composite lead (commonly a yellow RCA jack). Depending

on camera output it may require reverse to be supplied by a 12V switched ignition rather than reverse feed. To test this

use a multimeter set to DC and connect the (-) lead to the camera RCA shield and the (+) lead to the camera RCA tip with

the camera powered ON.

Powering up the camera - The mirror stays ON for over 1 second when reverse is disengaged and if the camera is

connected to the reverse tail lamp then the screen will flash Blue. If the camera does not power up instantly when the

vehicle is shifted into reverse the screen will not detect the camera and will not display an image. For these reasons we

recommend that the camera be connected to Ignition (+).

Install Temperature Probe (9002-6008):

Mount Temperature Probe behind grille in a well ventilated area making sure that it is not close to the radiator for best

temperature reading.

Route the supplied cable through the firewall (RECOMMENDED: Use an exisitng grommet OR drill a new hole as a pass-

thorugh and apply a small dab of silicone caulk to the cable to prevent the exposed metal from cutting the cable). Next,

route the supplied cable up the A- pillar to the 16 pin connector. Located on the bottom side of the mirror connector is a

rectangular white tab (see Figure 1). This tab must first be released A small flathead watch repair screw driver works best.

The tab will only lift about 1/10

of an inch.

Figure 1

Insert the Red lead of the Temperature Probe into cavity 6 and the Black lead into cavity 7.

White dot

identifies

cavity 1

1 2 3

Inhaltsverzeichnis

Seite 1 - Display Mirror)

9516 Instructions 9-27-12 Tel 734-619-1250 1 of 3

Seite 2 - Mirror Harness Pinout*

9516 Instructions 9-27-12 Tel 734-619-1250 2 of 3

Seite 3

9516 Instructions 9-27-12 Tel 734-619-1250 3 of 3

Kommentare zu diesen Handbüchern

Keine Kommentare

Brandmotion 9002-9516 Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Für das Auto Brandmotion 9002-9516 herunter. Brandmotion 9002-9516 User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Für das Auto Brandmotion 9002-9516